Hi!
I have two blocks to mesh, one into each other, in a 3D environment.
The smaller one (inside) is the thin film:
width = 100 µm
depth = 9 µm
height = 20 nm
The bigger one (outside) is:
width = 200 µm
depth = 20 µm
height = 20 µm
The two block are obviously centered one each other.
Any suggestion on how to mesh this geometry?
I have two blocks to mesh, one into each other, in a 3D environment.
The smaller one (inside) is the thin film:
width = 100 µm
depth = 9 µm
height = 20 nm
The bigger one (outside) is:
width = 200 µm
depth = 20 µm
height = 20 µm
The two block are obviously centered one each other.
Any suggestion on how to mesh this geometry?
